产品特性:
导电PVC地板粘结剂
导电功能持久有效
导电电阻值小于1*10'欧姆
越大涂布量
优异的粘结力
水性环保
施工方法:
使用前应充分搅拌均匀,建议用A1、A2锯齿刮刀均匀的涂刮,铺展后晾胶时间在5-30分钟,即可铺设上述地面材料。
注意事项:
铺下地板后先用软木板推压,再用30kg以上的辊筒滚压以排除残余的空气,确保粘合剂全部粘合到地板的背面。要确何良好的通风和对施工最佳的温度和湿度条件。低温或高温度会明显地延知干燥时间或推迟粘结强度的发展。在粘结剂的强度还未完全达到前,要防止过度使用。
Features:
Conductive
PVC flooring adhesive
Conductive
lasting and effective
The
conductive resistance value is less than 1*10'ohms
Large
amount of coating
Excelent
Bonding Strength
waterborne
environmental protective
Construction
Method:
Stir
it evenly before usage. It is suggested to use A1 or A2 sawtooth blade and lay
the ground for 5 to 30 minutes before laying the materials above.
Notices:
Press the new laid floor by soft wood panel then
a roller (more than 30kg) to remove the redundant air to ensure the adhesion
between the bonding agent and the floor. Ensure the good ventilation,
temperature and humidity for construction. Lower or higher temperature may
delay the time for drying or influence the bonding strength. Don't over use it
bafore the bonding strength is not reached. S